This is a 2 fan set up designed for an easy clamp on install for any style, any model, any brand, or any size cooling unit coils. The 2 fan set up will come with wiring harness, automatic thermostat to activate the fans when the air temp reaches around the 85 degree or warmer behind the refrigerator when the cooling unit is needing the higher flow of air through the condenser fins. The thermostat is at the end of the wire harness next to the fans anbs hangs loose not mounted. When you install fans and ready to wire the fans, all that's needed is a 12VDC positive (from any source) and a good DC frame ground (from any source). If you want to connect to the refrigerator DC, the wire harness will come with a piggyback terminal so you do not need to cut any original wires to use fan harness wiring. All wire terminal for hook up are furnished and already crimped to wire harness.
No holes drilled at any time to mount fans or brackets.
The fan specs are:
DC Brushless Fan Motor
Fan Motor has Ball Bearings
DC 12 volt range 10.2 to 13.7
Amp draw 0.15a
3000 RPM
CFM Air flow 46.46
dBA 28.58
each fan size: 92 x 92 x 25 mm or 3 3/8 x 3 5/8 x 1 inch
You can also omit the thermostat (furnished) that's with unit an install your own toggle switch (not furnished) to turn fans ON or OFF as you choose or you can use the furnished thermostat to activate only of one fans and use your toggle switch to activate the second fan in very hot weather.
Fans are only used to produce good air flow through the condenser fins, not there to remove heat from the compartment area. The condenser fins are located at the very top of the cooling unit coils.
In the above listing the toggle switch mentioned is not part of the listing and not furnished by us.
The above listing is Dual Fan Kit, not an item that is an OEM replacement part for any brand refrigerator.
To install this on very small cooling units with smaller diameter coils you may need to modify the holder clamps to work. This is for very small single door refrigerator 2 cu ft sizes.