This 2 Fan add on Kit , is a very easy install, usable on any brand or model RV refrigerator. You will get with this 2 Fan kit the mounting hardware, Wire Harness, Automatic Thermostat and a master 12Volt DC power ON-OFF toggle switch mounted in a holder, and built in fuse.  

 We have an 2 after market Flush Mounted FAN kit that will increase the flow of air through the Condenser fins for fast removing the heat that was pulled from the inside refrigerator, this will allow cooling of the inside of the food zone to cool faster and able to maintain cold during the hottest of weather when you have a good flow of air through the condenser fins..

The most important way for getting your RV refrigerator to cool correct, is good flow of air through the condenser fins. Fans are not used to remove heat from the compartment, they are only used to increase air flow through the condenser fins.  Most RV refrigerators need the increased air flow when the out side temps reaches 85 degrees or higher.

The thermostat is at the end of the harness an it hangs loose metering the air temps to turn ON or OFF Fan/Fans automatically at temperature range of 85 to 90 degree is reached behind the refrigerator.

Fan over all size and Specs.

4 3/4 by 4 3/4 by 1 1/4

RPM 2300

Amp 0.25

DC voltage up to 13.7v

DC Brushless

Ball bearing

Fans can be mounted any way you want, regardless where or how they are mounted as long as the flow of air goes through the condenser fins.

These FANS are a great add-on for any refrigerator in a slide out room to help the air to exit out the upper vent with the baffle closing the gap from the RV wall to the condenser fin so no wasted air is lost bypassing going through the condenser fin. You can zip tie one of the 12032 Fans to the upper vent door if you choose just extend the wire of one of the lead of the harness fan lead for this style set up.